CLEANING & MAINTENANCE
Note: Turn off the device before performing any of the following steps!
MAIN BRUSH
The provided cleaning brush has sharp blades, keep it out of reach of children.
1. Disassemble the main brush by turning the robot over, lift the buckle and take
out the main brush.
2. Clean it by using the provided cleaning brush. Use the side with the hook to
pick up and cut hair and fibre and separate it from the main brush. Use the
cleaning brush to clean surface dirt. We recommend replacing the main brush
every 6-12 months.
SIDE BRUSH
1. Turn the robot over. Use a screwdriver to remove the screws and take off the
brush.
2. Clean it by using the cleaning brush that comes with the product. Use the side
with the hook to pick up and cut hair and fibre and separate it from the side
brush. Use the brush to clean the surface dirt. We recommend replacing the
side brush every 6-12 months.
TWO-IN-ONE WATER TANK AND DUSTBIN
Do not soak the water tank while cleaning the dust compartment. It is
recommended to replace the filter with an original one every 3-6 months to
ensure cleanliness.
1. Press the release button on the tank and pull it out.
2. Open the cover and throw the rubbish. Use the cleaning brush to clean it.
3. Take out the filter holder, remove the filter and clean it with the cleaning
brush.
4. Rinse the filter with clean water and allow it to air dry completely before reinstalling
it.
5. Rinse the dustbin compartment with clean water and allow it to air dry
completely before re-installing it. Make sure the parts are completely dry
before installing them. This is to prevent malfunction and dust clumping.
MOP
It is recommended to replace the mop with an original one every 3-6 months to
ensure cleanliness.
1. Remove the mopping module from the 2-in-1 water tank and remove the mop
from the mop holder.
2. Rinse the mop with clean water and allow it to air dry before using it again.
ROBOT
Do not use wet wipes, detergents, sprays or other chemical products to clean the
sensors, infrared recharging sensors, or charging electrode plates of the robot.
Use a soft and clean cloth to wipe the laser distance sensor, infrared lens,
charging electrode plates and cliff sensors.
